Enhance the look of your 2025+ Toyota Camry with these smoked tint pre-cut reflector overlays! Designed specifically for the Camry SE, XSE, and XLE models (including Hybrid), these overlays provide a sleek, smoked appearance for your rear bumper reflectors.

Features:

• Perfect Fit: Compatible with 2025+ Toyota Camry SE / XSE / XLE / Hybrid rear bumper reflectors.
• Smoked Tint: Gives your reflectors a stylish, darkened look.
• High-Quality Material: Durable construction ensures 5-7 year lifespan, resisting all weather conditions.
• Nano Air-Release Technology: Made with high gloss material and nano air-release for easy, bubble-free application.
• Easy Peel-and-Stick Application: Simple to install; just peel and stick!
• Complete Set: Includes 2 pieces (left and right) for a complete smoke-out effect.
• Important Note: These are overlays, not replacements for the actual reflectors. They adhere directly onto your existing rear bumper reflectors.

Installation Instructions:

For best results, gather these tools: Heat Gun or Blow Dryer / Padded Glove or Felt Tip Squeegee.

1. Prepare the Surface: Thoroughly clean the side mirror chrome trim with soap and water to remove any dirt or debris.
2. Peel and Position: Carefully peel off the reflector overlays. Important: If you make a mistake, you can easily peel off the overlay and reposition it before applying heat.
3. Alignment: Align the edge of the overlay towards the middle of the car.
4. Application: Lay down the flat portion first, until the chrome trim splits into two sections. Apply either the top or bottom section first, allowing air to escape as you go.
5. Guide and Smooth: Lay the remaining section, using a small amount of force to guide its placement. Slowly lay it down, pushing out any air bubbles as you smooth the overlay.
6. Address Wrinkles: If wrinkles appear, gently lift the overlay and apply heat until the wrinkle disappears. Then, re-apply to the desired position.
7. Trim Excess (If Necessary): If any excess vinyl extends beyond the reflector surface, carefully wrap it around the chrome trim, tuck it into crevices, or trim it off with a thin blade.
8. Finalize Placement: Refer to the product photo for exact overlay placement.
9. Adhesion: Once you're satisfied with the placement, post-heat the vinyl using a blow dryer or heat gun. This activates the adhesive and improves tackiness.
10. Remove Bubbles: Firmly press any remaining bubbles with your finger and swipe them towards the nearest edge.
11. Mistakes: If you make a mistake, simply peel off the overlay and apply heat to remove any wrinkles.

Remember to post-heat the vinyl after installation to ensure optimal adhesion!