Volkswagen Jetta GLI Sedan - Pre-Cut Smoke Tint - Fog Light Overlay

The Fog Lights on the Jetta might be some of the easiest pieces to change up out of all the fog lights out there. Which is perfect for any DIYer hoping to change up the look of their front end. Whether you are choosing our smoke option or our Rally Yellow option the install is the same and should only take a few minutes. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this pre-cut tint overlay.

INSTALL GUIDE

TOOLS REQUIRED: SPRAY BOTTLE WITH WATER, PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product

INSTALLATION: Getting the vinyl installed on your ride is very easy and only requires minimal tools. First you need: lubrication spray solution. You can make a lubrication spray solution at home by using a spray bottle filled with water and mixing it with 1 drop of dish soap or buy our PRE-MIX SOLUTION SOLD HERE, You'll also need an application squeegee. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed as low as 50 degrees (F), and up to 90 degrees (F).

After the surface is clean and you have read and completed the preparation process, only then can you continue on with the next step. Next, lightly mist the surface you will be applying the overlay too, then peel the overlay from the backing paper, spray the adhesive side of the material.

Start by aligning the top edge and outer corner (corner facing towards the grille) of the overlay. Once both the corner and top edge are aligned, the rest of the overlay will fall into place. No Trimming required.

Once alignment has been confirmed, use a squeegee to adhere the tint to the surface. When using the squeegee, be sure to use firm pressure in order to remove the water from underneath the tint. If you do not use enough pressure you will leave behind pockets of air and water.

SPECIFICATIONS

• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.

• Car wash safe.

• Can be removed without any damage to surface.

• 1-3 year life expectancy.

• Check your local laws and regulations

>> DISCLAIMER INFORMATION

DIFFICULTY RATING: 1/5

MORE >> Difficulty Rating Information