Description
This portable ultrasonic cleaner uses high-frequency ultrasonic vibrations combined with ultraviolet light to clean and sanitise small personal items. It is designed for use with aligners, retainers, mouthguards, dentures, night guards, jewellery, and electric toothbrush heads.

The device operates using ultrasonic vibration technology to loosen and remove visible and invisible residue, while micro-bubbles help flush debris from small gaps. UV light provides an additional sanitising function. Cleaning requires water only, with no added chemicals.

The rechargeable unit is designed for convenient use at home or while travelling. A full charge takes approximately 2 hours and provides up to 3 hours of runtime, allowing for multiple short cleaning cycles. Operation is quiet during use.

Directions
Usage instructions:

1. Open the lid and place the item to be cleaned into the unit without turning it on.

2. Add water to the tank, ensuring the level does not exceed the marked maximum line.

3. To start the base unit, press and hold the power button for 1.5 seconds. A green indicator light will appear and the unit will run for 3 minutes before stopping automatically.

4. For intermittent cleaning, press the button again while operating to activate blue light mode. This runs for 5 minutes, cycling on and off every 5 seconds.

5. To stop the unit early, press and hold the power button for 1.5 seconds, or allow the cycle to finish automatically.

6. To activate UV sterilisation, press and hold the lid button for 1.5 seconds. The UV light will switch off automatically after 5 minutes.

7. Once cleaning is complete, open the lid, remove the item, empty the water, and dry the unit with a clean cloth or paper towel.

Charging instructions:
Open the protective cover over the charging ports and connect the charging cable to a power source. A red pulsing light indicates charging. Once charging is complete, disconnect the cable and ensure the cover is securely closed.

After use:
Empty the water tank, rinse with clean water, and allow the unit to dry with the lid open. For deeper cleaning, use a soft sponge with water. If needed, add 1–2 drops of neutral detergent, then rinse thoroughly. Clean the exterior with a damp cloth and dry. When emptying water, pour from the side to avoid contact with electrical components.

Warnings
Always read the label and follow the directions for use.
Do not use adapters other than those supplied.
Do not handle the power plug with wet hands.
Disconnect from power when not in use for extended periods.
Exposure of electrical components to water may cause damage or malfunction.