Fits 2011-2022 5.0L Coyote engine (requires custom calibration for 2011-2017 coyote engines)

This is a brand new unused production 2018-2023 Mustang GT intake manifold assembly from Ford. We take these off brand new, never ran Generation 3 5.0L Coyote crate engines. 
This assembly serves as a direct replacement for the 2018-2023 Mustang GT and bolt-on upgrade for all 2011-2017 Mustang GT or any early generation 5.0L Coyote engine. 

This assembly comes assembled from Ford with new unused OE:

• 85 mm. Electronic Throttle Body And Motor Assembly
• 2 x Actuator Assembly
• 8 x 34lb. Injectors
• Fuel Supply Manifold Assembly
• Fuel Injection Pressure Sensor
• Passenger Side PCV Valve Hose
• Intake Manifold and Throttle Body Gaskets

When upgrading to this intake manifold you are guaranteed to improve the horsepower and torque output of Generation 1 (2011-2014) and Generation 2 (2015-2017) 5.0L Coyote engines because of increased intake runner length, cross-section, and total intake volume.

Note: GEN 2 5.0L COYOTE powertrains require CMCV harness adapters (if you want to retain use of the CMCV / IMRC / CMRC system) or CMCV lockouts, and a custom tune calibration. While GEN 1 5.0L COYOTE powertrains require IMRC / CMRC lockouts and a custom tune calibration.

Installation Instructions 

 ⚠️ Warning: The products identified on this page can expose you to chemicals including lead, DEHP and other chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65warnings.ca.gov