2015-2020 Subaru WRX / STI - Tail Light Insert With Custom Cut Out Overlays

This Custom Vinyl overlay drastically changes the entire look of your stock tail light for a fraction of the cost of retro-fitting or aftermarket tails. There are a lot of options out there for the WRX and STI platform but we set out to create something different to give people another look, that they themselves could install on their vehicle. Along with a full install guide and video on our youtube channel to walk you through the process. This easy peal and stick vinyl accent overlay looks OEM when properly installed. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay. Check your local laws and regulations prior to purchasing. Disclaimer information attached below.

INSTALL GUIDE

NOTE: This Product includes two separate products, one being a wet tint install (TL125), the other being a dry wrap install(TL168). The Red Tint piece should be installed first, then the gloss black overlay ontop.

TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product

Part 1: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.

Part 2: After the surface is clean and you have completed Part 1, start with the red tint overlay (TL125). Mist the surface you will be applying the overlay to with water then place the overlay into place following the outer edges of the clear section of the tail light. Using a profelt squeegee, apply firm pressure to the overlay starting from the center of the tint moving outwards until all moisture is removed from underneath the surface. Use a heat gun to post heat this product before continuing to the (TL168) Gloss Black Overlay.

Now to install the second piece of the overlay. With the transfer tape attached to your gloss black custom cut out insert overlay, take your tail light insert and line up the overlay with the tail light's outer edge that faces towards the trunk. Once aligned the rest of the overlay will fall into place. Squeegee the material down. Remove the transfer tape. Post heat the product, and the installation is complete.

SUPERIOR QUALITY

• Adhesive backed film for easy installation and removal.

• Maintenance free & car wash safe.

• Can be removed without any damage to surface.

• 1-3 year life expectancy.

• Check your local laws and regulations

>> DISCLAIMER INFORMATION

DIFFICULTY RATING 1/5

MORE >> Difficulty Rating Information

Start the video @6:33 for the installation of this product.