Automatic RULE LP900S LoPro bilge pump 12volt

The automatic LoPro includes all features as detailed further above with the additional benefit of automatic operation in multiple modes - NO float switch is required.

• High or low water sensing mode - the pump can be set to start operation at either 33mm or 50mm bilge water height
• Electronic automatic timer mode - The pump can be set to automatically check for water every 2 1/2 minutes - if water is present it will continue to run and pump bilge water. This feature is very handy - however if you leave the boat unattended on a mooring it may run down the battery over time, if you dont have solar panels or a wind generator Etc to constantly charge the battery - in this case set the pump only to high or low mode
• Includes pump test mode
• Includes manual over-ride 3rd wire - requires a Rule 3 way
• panel switch RWB23 or 107 to operate this feature - see page 282
• 12 volt 4 amp use a 7.5 amp fuse
• 12 volt DC only - DO NOT run direct off a 240v-12v transformer