Doug Fleenor Design DMX8DIM 8 Channel 250W Dimmer Junction Box

The DMX8DIM is an eight output ‘green' dimmer designed for high efficacy loads, low idle power, and minimal losses. Typical loads include LED lamps, Neon, Compact Fluorescent, and low power halogen. The dimmer electronics are housed in a 12x12x4 inch NEMA Type 1 enclosure and are easily removable so the enclosure can be installed and rough wired without the electronics in place. Then, upon completion of dry wall, the electronics can be reinstalled using only four screws.

Technical Specifications

Input circuit
Protected EIA-485 receiver (LT1785). Transient protected to 15 KV, Continuous to 60 V.
Input signal
0.2 volts minimum, 12 volts maximum, DMX512, DMX512/1990, or DMX512-A.
Signal Connectors
Phoenix Contact Combi-Con Pluggable terminal blocks. Two provided: In and Through.
Termination
Removable 120 Ohm termination provided on feed through.
Power Input
120 VAC 60 Hz 16 Amps at full load (Uses 20 Amp branch circuit at 80% capacity).
Actual current draw is connected load plus 50 mA (max).
Idle Power
Less than 1 Watt.
Input Power Connector
Three position screw terminal block accepts up to 12 AWG solid or stranded wire (Line, Neutral, Ground).
Power Output
120 VAC 60 Hz 250 Watts per output.
Output Protection
2 Amp self-resetting over current device on output, 100 Ohm PTC thermistor on driver.
Output Connectors
One three position screw terminal block per output accepts up to 12 AWG solid or stranded wire (Line, Neutral, Ground).
Size and Weight
12"H - 4"D - 12"W, 10 Pounds