Treatex Douglas Fir Protection is a solvent free exterior wood finish which offers long lasting weather protection. It is manufactured on a base of natural sustainable raw materials including linseed oil, sunflower oil and soybean oil.

Preparation

Treatex Douglas Fir Protection will only work on unfinished timber. Previous finishes must be fully removed prior to application. Ensure the timber is dry and free from possible contaminates e.g. algae, grease, dirt, dust etc. Timbers susceptible to decay, mould and fungi should be treated first with a suitable preservative. We advise that when using Treatex Douglas Fir Protection, sufficient product is purchased to complete the whole project and when more than one tin is required it is advisable to mix them together before use. Timber must have a moisture content below 18%. Temperature must be greater than 8 degrees during application and drying. We strongly recommend a trial application prior to starting the project.

Application

Do not apply in damp, humid conditions. Stir container thoroughly, before and during use. Use a brush to evenly apply Treatex Douglas Fir Protection in the same direction as the wood grain, allowing approximately 125ml per m√¢ÀÜŒ. Pay particular attention to end grain, on end grain apply wet on wet until product is no longer absorbed by the timber. After approximately 3-6 hours the first coat can be overcoated. The second coat must be applied within 24 hours. Apply with a brush a second coat of Treatex Douglas Fir Protection, again allowing roughly 125ml per m√¢ÀÜŒ. After the second coat it will take up to 24 hours for the product to fully dry. This product can look milky when first applied however it dries to a transparent brown. Treatex brushes are available. Wet brushes can be cleaned with warm soapy water. Store containers in a cool and frost free environment. Unopened containers will last for three years. Once containers are opened, transfer contents to a smaller airtight container.