Marca: BOSS Audio Systems

Caracteristicas:

• 500 Watts MAX 250 Watts RMS Power Handling per Pair
• 50 Hz to 20 kHz Frequency Response and 92dB Sensitivity
• Poly Injection Woofer Cone and Rubber Surround
• 2 Tweeters and 2.5 inch Mylar Dome Midrange Per Speaker

Detalles: Descripción Full Range, Class A/B Topology A class A/B amplifier uses two groups of transistors and it is generally considered to be the best compromise of the two classes - A and B - put together. A pure class A amplifier typically has an enormous amount of current flowing through its output transistors with no audio signal. A pure class B amplifier has no current flowing through its outputs with no audio signal. A class A/B amplifier is much more efficient than a class A, but without the possible distortion of a class B. MOSFET Power Supply A Metal–Oxide–Semiconductor Field-Effect Transistor is a transistor used for amplifying or switching electronic signals, found in systems where information is processed or stored. We use them in our computers, telephones, game consoles, cars, electrical appliances, and, in this case, amplifiers. A MOSFET is basically an electrical switch with two possible states - on or off - that allows the flow of electrical current. The MOSFET performs its most important role in our D Class amplifiers by allowing or preventing the flow of power and creating an efficient amplifier. General Features Bridgeable outputs Tri-mode capable 2 Ohm stable operation with output power increase Thermal and speaker short protection Soft turn-on circuit Remote turn on/off circuit Gunmetal gray heatsink 2/1 Channel This versatile feature comes in handy for a couple of different installation applications. The “2” channel means that you are able to simply use the AR1200.2 as a two channel amplifier by hooking up two speakers to it. The “1” channel allows you to hook up one subwoofer in bridged mode. Variable Bass Boost With the AR1200.2 Amplifier, you get variable bass boost. This feature gives you control of exactly how much bass you want to pump out to your subwoofers, whereas with regular bass boost you would either have extra bass, or not. Low And High Level Inputs There are two different ways that you can get a signal into Armor series amplifiers: high and low level input. Low level input is measured in voltages and comes in the form of RCA outputs from the back of your receiver, going to the RCA inputs on your amplifier. High level input is measure in wattages, and comes in the form of one positive and one negative wire from the back of your receiver, going to the input terminal of your amplifier in the same wire form. Low-level input wiring is preferred for best audio performance. Always use a high-quality RCA cable for the best audio performance. NOTE: Do not connect both the high and low level inputs from your receiver to your amplifier at the same time. Variable Crossover Speakers reproduce sound based on high, low, or mid-range frequencies. This process is called the crossover effect, and it occurs because many audio systems cannot cover the entire spectrum sufficiently to minimize sound distortion and maintain an appropriate frequency ratio. With the AR1200.2 amplifier, a variable crossover is offered so that you have the ability to set the frequency at which the crossover occurs. You can set specific sound specifications such as the bass, mid-range, and high frequency reproduction. Nickel Plated RCA Low Level And High Level Inputs LED Power And Protection Indicators

Binding: Electrónicos