2016-2019 Honda Civic Coupe

This simple overlay takes the existing clear portion of your tail light and upgrades it without you even having to open it up. Retrofits can be time consuming and costly. This solution gives your rear end a fluid look to the clear portion of the tail light that we believe should have been the look the car came with from the factory. It is very easy to apply and leaves you with an OEM+ look without any restriction to your light out put. Unlike most ebay or amazon vendors, Premium Auto Styling vinyl overlays are designed and produced here in the USA in our own facility. We design and test fit all products to ensure fitment guaranteeing you the best results . Basically, if they don’t work on our cars, they’re not going to end up on yours. If you are looking for an inexpensive styling modification, or you just want to change up the factory look, it's a great idea to checkout this vinyl overlay.

INSTALL GUIDE

TOOLS REQUIRED: PRO FELT SQUEEGEE, HEAT GUN or Warm Sunny Day to Post Heat the product

DRY INSTALL BASICS: Getting the vinyl installed on your vehicle is very easy and only requires minimal tools. For Best results we recommend cleaning the surface that you'll be applying our overlays too, cleaning should consist of removal of any waxes, dirt and or debris. For the cleaning process a clay bar is highly recommended: CLEANING PREP SPRAY & CLAY BAR's SOLD HERE). Before you begin installation of any vinyl overlays please make sure you are working in the right conditions, you should never install vinyl in direct sunlight, never apply vinyl in temperatures that are neither too hot nor too cold. Our in-house expert installers say the optimum temperature for installing vinyl is between 65 and 72 degrees (F). Vinyl can be installed in temperatures as low as 65 degrees (F), and up to 90 degrees (F). Vinyl has a more difficult time conforming and staying in place in colder temperatures though, which is why we recommend waiting until temperatures warm up or install in a temperature controlled environment.

FULL INSTALL: After the surface is clean and you have read and completed DRY INSTALL BASICS, Start by removing the vinyl from the backing paper while keeping the clear transfer tape attached, this will insure that the custom cut out does not lose its shape during placement. Now for the easy part, simply align the bottom corners and the bottom edge along the bottom edge of the clear portion of the tail light. Once Aligned the rest of the overlay should fall right into place. Lay the material while using firm pressure with a squeegee, go over the entire product making sure the vinyl has adhered fully. Now take a corner of the transfer tape and begin to slowly peel it back on itself. This will help decrease the pull it has on the vinyl as opposed to pulling the transfer tape off straight towards yourself. If an area begins to lift while pulling the transfer tape, simply lay it back down, squeegee again and proceed with removing the transfer tape. Tuck or trim around the edges if your placement has caused any excess vinyl to fall just over the edges of the clear portion of the tail light. Post heat the material and the install is complete.

SPECIFICATIONS

• Automotive Grade Adhesive backed vinyl with air release technology for easy installation and removal.

• Car wash safe.

• Can be removed without any damage to surface.

• 1-3 year life expectancy.

• Check your local laws and regulations

>> DISCLAIMER INFORMATION

DIFFICULTY RATING: 2/5

MORE >> Difficulty Rating Information

CUSTOMER REVIEW VIDEO